I was working on a work unit that had gone for 2 hours and was still and 1% completed. I was forced to do a reboot, a program locked up, and this restarted the work unit, since now chack point had been taken.

Now after one hour, it is 52% complete. So it seems the work unit was stuck and then freed itself after the restart.

This is the work unint: https://boinc.bakerlab.org/rosetta/result.php?resultid=14743295

I debated if I should put this in the 'Stuck and aborted' thread, since I did not technically aborted the work unit.

---