Each of my three Macs has started a WU today and after 1.5 - 6.5 hours, they all are at 1.xxx% completion. Should I Suspend & Resume them, or Abort them?

I saw something about this somewhere but was under the impression that it was a bug that had been addressed.

---

Don't abort it.
If it is an error in the WU, it will be detected and aborted automatically.
But it's possible that it's a complete normal WU.
To explain this (you can find this story in several postings on this board):

* When a WU is started, it is getting initialized. If this is finished, you get 1.xx% done.
* After the first model is finished, it percentage increases.
* If it is a complex model, it will last longer than a simple model.
* Depending on your settings (for the default runtime), after this first model it will take a look if it is going to start a second model
* etc

So it is possible that you'll see the WU 'hangs' at 1% and after several hours it goes almost immidiatly to 100%

---

Member of Dutch Power Cows

Thank you. Hopefully when I get up in the morning all will be good!

---

Each of my three Macs has started a WU today and after 1.5 - 6.5 hours, they all are at 1.xxx% completion. Should I Suspend & Resume them, or Abort them?

I saw something about this somewhere but was under the impression that it was a bug that had been addressed.

If they are stuck: the Terminator function in the program will catch it. Do not abort!!!. Please remember that unless a "decoy is "built"progress seems to stop at 1.00..%. The program only updates progress % after a model/decoy is "built.

---

This and no other is the root from which a Tyrant springs; when he first appears he is a protector.”
Plato